Enable NAT for a subnet

Each subnet (directly-attached or routed) must have a unique address space within your Magic WAN. You can re-use address spaces locally by enabling static network address translation (NAT) for a subnet. NAT is static. This means that inbound connections - from Magic WAN to the site behind the Connector - are allowed, and connections do not have to be initiated by hosts behind the Connector. NAT is also 1:1, that is, the Connector will translate between corresponding addresses in two equal-sized prefixes.

To enable NAT, supply a WAN-facing address prefix the same size as the subnet's prefix, and the Magic WAN Connector will translate between the two.

For example:

• Prefix: 192.168.100.0/24
• Static NAT prefix: 10.10.100.0/24

With the example above, outbound traffic from host 192.168.100.13 in the subnet is translated to 10.10.100.13 in the Connector (and vice versa for incoming traffic).

Note

Even if NAT is enabled, the local prefix for a subnet must be unique within its LAN. It can, however, be reused on other LANs or other sites. Overlay-facing prefixes - that is, a subnet's NAT prefix if NAT is enabled, and its local prefix otherwise - must always be unique across your whole Magic WAN.

Create NATs for subnets

For more information on how to a create a NAT for a subnets, refer to Create a LAN, either in Configure hardware Connector or Configure virtual Connector.

Was this helpful?

What did you like?

Accurate

Easy to understand

Solved my problem

Helped me decide to use the product

Other

What went wrong?

Hard to understand

Incorrect information

Missing the information

Other

Thank you for helping improve Cloudflare's documentation!