Skip to content

Enable NAT for a subnet

Each subnet (directly-attached or routed) must have a unique address space within your Magic WAN. You can re-use address spaces locally by enabling static network address translation (NAT) for a subnet. NAT is static. This means that inbound connections — from Magic WAN to the site behind the Connector — are allowed, and connections do not have to be initiated by hosts behind the Connector. NAT is also 1:1, that is, the Connector will translate between corresponding addresses in two equal-sized prefixes.

To enable NAT, supply a WAN-facing address prefix the same size as the subnet's prefix, and the Magic WAN Connector will translate between the two.

For example:

  • Prefix: 192.168.100.0/24
  • Static NAT prefix: 10.10.100.0/24

With the example above, outbound traffic from host 192.168.100.13 in the subnet is translated to 10.10.100.13 in the Connector (and vice versa for incoming traffic).

Create NATs for subnets

For more information on how to a create a NAT for a subnets, refer to Create a LAN, either in Configure hardware Connector or Configure virtual Connector.