Get started
To begin using Magic Network Monitoring, complete the list of tasks below.
If you are an Enterprise customer, Cloudflare can significantly accelerate the onboarding timeline during active-attack scenarios. Enterprise customers that would like to use Magic Network Monitoring and Magic Transit On Demand together can begin by configuring Magic Transit.
Verify your routers are capable of exporting NetFlow or sFlow to an IP address on Cloudflare’s network. Magic Network Monitoring supports NetFlow v5, NetFlow v9, IPFIX, and sFlow.
Refer to Supported routers to view a list of supported routers. The list is not exhaustive.
When you register your router with Cloudflare, your router links your NetFlow or sFlow data to your Cloudflare account.
- Log in to your Cloudflare dashboard ↗, and select your account.
- Go to Analytics & Logs > Magic Monitoring.
- In Magic Network Monitoring Analytics, select Configure Magic Network Monitoring.
- Select the Configure routers tab.
- Under IP Address, enter your router's public IP address.
- Under Default router sampling rate, enter a value for the sampling rate. The value should match the sampling rate of your NetFlow or sFlow configuration.
- Select Next.
Next, configure your router to send NetFlow/SFlow data to Cloudflare. For this step, you will also need to have your router's configuration menu open to input the values shown in the Cloudflare dashboard.
Refer to the NetFlow/IPFIX configuration or the sFlow configuration guide for more information.
- From Configure routers in the dashboard, select either NetFlow Configuration or sFlow configuration.
- Follow the configuration steps for the selected configuration type.
- Enter the values shown in your router's configuration.
- Select Next.
After setting up your router, confirm the configuration was successfully set up.
From the Check routers page on the dashboard, you can view the status of your routers. Keep in mind that router data takes five to ten minutes to be sent to Cloudflare.
Refer to Router status description to confirm whether data is successfully being sent.
When you are done with router configuration, select Finish onboarding.
Create rules to analyze data for a specific set of destinations or to implement thresholds. Refer to Rules for more information.